REAR SPEED SENSOR(for 4WD/AWD) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    1. Remove the deck trim side panel LH (Click hereClick here).

      Tip:

      Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.

  3. REMOVE REAR SPEED SENSOR LH

    1. C127328

      Disconnect the speed sensor connector.

    2. C274701

      Disconnect the grommet of the speed sensor wire from the hole of the wheel house.

    3. C274702E01

      Remove the bolt labeled A and sensor clamp labeled B from the side member.

    4. Remove the 2 nuts labeled C and sensor clamps labeled D from the upper arm.

    5. C274703E01

      Remove the nut labeled E and sensor clamp labeled F from the trailing arm.

    6. Remove the bolt labeled G and sensor body labeled H from the carrier.

      Note:

      Keep the sensor tip and sensor installation hole free from foreign matter.