CRUISE CONTROL SYSTEM(except 1ND-TV, 8NR-FTS) Cruise Main Indicator Light Circuit
| DTC Code | DTC Name |
|---|---|
| Cruise Main Indicator Light Circuit |
DESCRIPTION
The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control indicator illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator changes to amber (w/ multi-information display (segment LCD type)), or the cruise control indicator goes out and a warning message is displayed (w/ multi-information display (dot LCD type)).
The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
PROCEDURE
PERFORM ACTIVE TEST USING GTS
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the cruise control indicator by performing the Active Test.
Body Electrical > Combination Meter > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Indicat. Lamp Cruise
Cruise control indicator (illuminated in green)
ON / OFF
-
Cruise Indicator
Cruise control indicator (illuminated in amber)
ON / OFF
w/ Multi-information Display (Segment LCD Type)
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Cruise
Body Electrical > Combination Meter > Active Test
Tester Display
Cruise Indicator
OK
The cruise control indicator goes on or off.
Result
Proceed to
OK
NG