FRONT SEAT OUTER BELT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A005BXWE01
      Text in Illustration
      *1 Pre-crash Seat Belt Connector
      *a

      Component without harness connected

      (Front Seat Outer Belt Assembly)

      Check the pre-crash seat belt. (w/ Pre-crash Safety System)


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always Below 1 MΩ

        • If the result is not as specified, replace the front seat outer belt assembly.

    2. A005B3OE14
      Text in Illustration
      *1 Retractor
      *a Unlocked
      *b Locked
      *c 45°

      Before installing the outer belt, check the ELR function.

      Note

      Do not disassemble the retractor.


      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

        If the result is not as specified, replace the front seat outer belt assembly.