LIGHTING SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data List.

    5. Read the Data List according to the display on the GTS.

      Body Electrical > Combination Meter > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Driver Side Door

      Driver door courtesy light switch signal

      CLOSE or OPEN

      CLOSE: Driver door closed

      OPEN: Driver door open

      -

      Door All (Except for Driver Side Seat)

      Any door (except driver door) courtesy light switch signal

      CLOSE or OPEN

      CLOSE: Any door (except driver door) closed

      OPEN: Any door (except driver door) open

      -

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Entry&Start* / Active Test.

      • *: w/ Entry and Start System

    5. Perform the Active Test according to the display on the GTS.

      Body Electrical > Entry&Start > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Power/Engine SW Light

      Engine switch illumination*

      OFF or ON

      When performing this Active Test, make sure the following conditions are met:

      The engine switch illumination is off (15 seconds or more have elapsed since it turned off) and the engine switch is on (ACC) or on (IG), or the engine is running.

      • *: w/ Entry and Start System