YAW RATE AND ACCELERATION SENSOR REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE REAR CONSOLE BOX ASSEMBLY

    1. Remove the rear console box assembly (Click here).

  3. REMOVE YAW RATE AND ACCELERATION SENSOR

    1. C219820

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector.

    3. Detach the clamp from the sensor bracket.