ENGINE HOOD COURTESY SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the engine hood courtesy switch (hood lock assembly) removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera view adjustment Panoramic view monitor system

Click here

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. for Sport Package:

      Click here

    2. except Sport Package:

      Click here

  2. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR


    1. B006FAD

      Remove the 2 clips.

    2. Detach the clamp and remove the hood lock release lever protector.

  3. REMOVE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. for LHD:


      1. B006D56C01
        B006AHR Bolt
        B006EC9 Connector

        Disconnect the connector.

      2. Remove the 3 bolts and engine hood courtesy switch (hood lock assembly) from the vehicle.

      3. B006GDX

        Disconnect the hood lock control cable assembly and hood lock control assembly from the engine hood courtesy switch (hood lock assembly) and then remove the engine hood courtesy switch (hood lock assembly).

        Note

        Do not bend the hood lock control cable assembly excessively.

    2. for RHD:


      1. B006FEMC01
        B006AHR Bolt
        B006EC9 Connector

        Disconnect the connector.

      2. Remove the 3 bolts and engine hood courtesy switch (hood lock assembly) from the vehicle.

      3. B006GAO

        Disconnect the hood lock control cable assembly and hood lock control assembly from the engine hood courtesy switch (hood lock assembly) and then remove the engine hood courtesy switch (hood lock assembly).

        Note

        Do not bend the hood lock control cable assembly excessively.