FRONT SPEED SENSOR (for 2WD) INSTALLATION

Tech Tips


  • The procedures listed below are for the LH side.

  • Other than areas where instructions are provided, use the same procedures for the LH side and RH side.


  1. INSTALL FRONT SPEED SENSOR LH


    1. A01DZG8E01

      Install the 2 harness clamps with the 2 bolts.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Note


      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    2. Install the speed sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • When installing the sensor, do not twist the wire harness.

    3. A01DYZPE01

      Install the harness clamp with the bolt.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Note


      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    4. A01E1AEE01

      Install the harness clamp with the bolt.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Note


      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    5. Attach the clamp.

    6. Connect the connector.

      A01DY0GE01

      Note


      • Do not attach the connector to the radiator fan shroud before connecting the connector.

      • Securely connect the connector.

    7. Attach the 2 clamps and the connector.

      Note

      When attaching the clamps, do not twist the wire harness.

  2. INSTALL FRONT WHEEL

    Torque:
    for steel wheel
    152 N*m  { 1550 kgf*cm, 112 ft.*lbf }
    for aluminum wheel
    121 N*m  { 1234 kgf*cm, 89 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.