ПОДОГРЕВАЕМЫЙ КИСЛОРОДНЫЙ ДАТЧИК (для датчика 2) УСТАНОВКА


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    A01DWWME03

    1. Using SST, install the sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf, for use with SST }
      44 N*m  { 449 kgf*cm, 32 ft.*lbf, for use without SST }

      Tech Tips

      Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

    2. Connect the sensor connector.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

    A01E0OEE03

    1. Using SST, install the sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf, for use with SST }
      44 N*m  { 449 kgf*cm, 32 ft.*lbf, for use without SST }

      Tech Tips

      Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

    2. Connect the sensor connector.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.