VEHICLE PROXIMITY NOTIFICATION SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.

    6. Read the Data List according to the display on the GTS.

      Table 1. Body Electrical > Vehicle Proximity Notification System > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Stop Light SW

      Stop light switch

      OFF or ON

      OFF: Brake pedal released

      ON: Brake pedal depressed

      -

      Permission Signal

      Vehicle proximity notification system permission signal

      OFF or ON

      OFF: Vehicle proximity notification system operation prohibited (engine is operating or shift lever is in P).

      ON: Vehicle proximity notification system operation permitted (engine is stopped and shift lever is not in P).

      -

      Operation Cancel SW

      Vehicle approaching speaker switch signal

      OFF or ON

      OFF: Vehicle approaching speaker switch off

      ON: Vehicle approaching speaker switch on

      -

      Vehicle Speed

      Vehicle speed

      Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)

      Almost the same as actual vehicle speed

      -

      Proximity Sound Volume Adjustment

      Warning sound volume setting

      Standard, Standard +1, Standard +2

      Customized value displayed

      -

      Proximity Sound Level Increase (Vehicle Starting)

      Warning sound amplifier function when vehicle starts off

      OFF or ON

      Customized value displayed

      -

      Proximity Sound Control (Vehicle Stationary)

      Warning sound setting function when vehicle stopped

      OFF or ON

      Customized value displayed

      -

      Number of DTC

      Number of trouble codes

      Min.: 0 Max.: 255

      Number of DTCs displayed

      -

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Active Test.

    6. Perform the Active Test according to the display on the GTS.

      Body Electrical > Vehicle Proximity Notification System > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Proximity Sound Indicator

      Proximity sound Indicator

      OFF or ON

      -

      Proximity Sound (Vehicle Stationary)

      Proximity sound (Vehicle stationary)

      OFF or ON

      Produces warning sound when vehicle is stopped

      Proximity Sound (Low Speed)

      Proximity sound (Low speed)

      OFF or ON

      Produces warning sound when vehicle is being driven at speeds of 10 km/h (6 mph)