BLIND SPOT MONITOR SENSOR INSTALLATION

PROCEDURE

1. INSTALL BLIND SPOT MONITOR SENSOR LH

   Note:

   • Avoid any impact to the blind spot monitor sensor LH.

   • Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.

   1. Connect the connector.

   2. Install the blind spot monitor sensor LH with the 3 nuts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

2. INSTALL BLIND SPOT MONITOR SENSOR RH

   Note:

   • Avoid any impact to the blind spot monitor sensor RH.

   • Do not drop the blind spot monitor sensor RH. If it is dropped, replace it with a new one.

   1. Connect the connector.

   2. Install the blind spot monitor sensor RH with the 3 nuts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

3. INSTALL REAR BUMPER COVER

   Click here

4. INSTALL REAR BUMPER BAR PLATE

   Click here

5. INSTALL JACK BOX HOLE COVER

   Click here

6. INSTALL REAR QUARTER PANEL MUDGUARD LH

   Click here

7. INSTALL REAR QUARTER PANEL MUDGUARD RH

   Tip:

   Use the same procedure described for the LH side.

8. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

   Click here

9. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here