PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A40

DTC Code DTC Name
C1A40 ENG / EHV Device

DESCRIPTION

When the driving support ECU assembly receives a SFI system or Automatic transaxle system malfunction signal from the ECM, this DTC is stored.

When DTC C1A40 is stored, the SFI system or Automatic transaxle system DTC will also be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A40 ENG / EHV Device While the engine switch is on (IG), a SFI system malfunction signal is detected for 3 seconds or more.

  • SFI system

  • Automatic transaxle system

  • ECM

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

PROCEDURE


  1. CHECK FOR DTCs (SFI SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Check for DTCs.

      w/ Canister Pump Module: Click here

      w/o Canister Pump Module: Click here


      Powertrain > Engine > Trouble Codes
      Result
      Result Proceed to
      SFI system DTCs are not output A
      SFI system DTCs are output (w/ Canister Pump Module) B
      SFI system DTCs are output (w/o Canister Pump Module) C

    B

    GO TO SFI SYSTEM Click here

    C

    GO TO SFI SYSTEM Click here

    A

  2. CHECK FOR DTCs (AUTOMATIC TRANSAXLE SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / ECT / Trouble Codes.

    5. Check for DTCs.

      U661E: Click here

      U661F: Click here


      Powertrain > ECT > Trouble Codes
      Result
      Result Proceed to
      Automatic transaxle system DTCs are not output A
      Automatic transaxle system DTCs are output (U661E) B
      Automatic transaxle system DTCs are output (U661F) C

    B

    GO TO AUTOMATIC TRANSAXLE SYSTEM Click here

    C

    GO TO AUTOMATIC TRANSAXLE SYSTEM Click here

    A

  3. REPLACE DRIVING SUPPORT ECU ASSEMBLY


    1. Replace the driving support ECU assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTCs


    1. Clear the DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Trouble Codes
      Result
      Result Proceed to
      DTC C1A40 is output A
      DTC C1A40 is not output B

    A

    REPLACE ECM Click here

    B

    END (DRIVING SUPPORT ECU ASSEMBLY WAS DEFECTIVE)