SHIFT AND SELECT LEVER SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE SELECT OUTER LEVER LOCK PIN


    1. B007Q4O

      Loosen the nut of the select outer lever lock pin until the top of the nut becomes flush with the end of the lock pin.

    2. B007PSU

      Using a brass bar and a hammer, disengage the select outer lever lock pin.

    3. Remove the nut, washer and select outer lever lock pin from the shift lever shaft housing assembly.

  2. REMOVE SELECT OUTER LEVER


    1. B007RRL

      Remove the select outer lever and washer from the select lever shaft sub-assembly.

  3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY


    1. B007OZO

      Remove the select lever shaft sub-assembly from the shift lever shaft housing.

  4. REMOVE LEVER LOCK PIN NO.2


    1. B007U95

      Loosen the nut of the lever lock pin No.2 until the top of the nut becomes flush with the end of the lock pin.

    2. B007OCW

      Using a brass bar and a hammer, disengage the lever lock pin No.2.

    3. Remove the nut, washer and lever lock pin No.2 from the shift lever shaft housing assembly.

  5. REMOVE SHIFT OUTER LEVER NO.1


    1. B007UVC

      Remove the shift outer lever No.1 from the shift and select lever shaft.

  6. REMOVE SHIFT LEVER BOOT


    1. B007SD3

      Remove the shift lever boot from the shift lever shaft housing.

  7. REMOVE SHIFT AND SELECT LEVER SHAFT


    1. B007TDW

      Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted pin.

      Note

      Be careful not to damage the shift and select lever.

    2. B007S8VE01

      Pull out the shift and select lever shaft from the shift lever shaft housing.

  8. REMOVE SHIFT AND SELECT LEVER


    1. B007R7O

      Remove the shift and select lever, select spring seat No.1 and spring from the shift lever shaft housing.

  9. REMOVE REVERSE RESTRICT PIN SLOTTED SPRING PIN


    1. B007S8G

      Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.

    2. Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.

  10. REMOVE REVERSE RESTRICT PIN NO.1


    1. B007OX0

      Remove the reverse restrict pin No.1 and compression spring from the shift lever shaft housing.

    2. Remove the compression spring from the reverse restrict pin No.1.

  11. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL


    1. B007UI7

      Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.

  12. REMOVE SHIFT LEVER SHAFT OIL SEAL


    1. B007P5S

      Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.