SUSPENSION CONTROL SYSTEM ADJUSTMENT

PROCEDURE


  1. ADJUST STANDARD VEHICLE HEIGHT

    Click here

  2. INSPECT VEHICLE HEIGHT


    1. Inspect the vehicle height.

      Click here

    2. Inspect the vehicle height.

      Click here

      Note

      The possible vehicle height automatic adjustment value is 25 mm. If the "Height Adjust value + (Standard value - Measurement value - After Height Adjust value)" is 25 mm or more, first perform the standard vehicle height adjustment (height control link adjustment).

  3. ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Front)

    Note


    • First adjust the height control sensor link that has the highest deviation from the standard value.

    • If the deviation of the front and rear link is the same, adjust the front link first.


    1. B006EMJ

      Loosen the 2 lock nuts on the height control sensor link.

    2. Turn the bolt of the height control sensor link to adjust the length.

      Tech Tips


      • If raising the vehicle height, lengthen the link.

      • If lowering the vehicle height, shorten the link.

      • Turning the bolt of the height control sensor link 1 revolution changes the vehicle height by about 6.9 mm (0.272 in.).

    3. B0069R8N01

      Check if the height control sensor link dimension shown in the illustration is less than the maximum value.

      Maximum dimension
      18 mm (0.709 in.)

    4. Tighten the lock nuts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      Make sure the ball joint and bracket are parallel when tightening the lock nuts.

  4. ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Rear)


    1. B006C9WC01
      *a Adjustment Range

      Adjust the rear vehicle height by moving the installation position of the link on the lower arm.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When the link is moved 1.0 mm (0.0394 in.), the vehicle height is adjusted by about 1.5 mm (0.0591 in.).

    2. Perform vehicle height offset calibration once again.

      Click here

    3. Inspect the vehicle height once again.

      Click here

  5. INSPECT WHEEL ALIGNMENT


    1. for Front:

      Click here

    2. for Rear:

      Click here

  6. ADJUST HEADLIGHT ASSEMBLY

    Click here