AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE

  1. INSTALL AIR FUEL RATIO SENSOR

    1. A210387C01

      *a

      Length of SST 30 mm (1.18 in.)

      *b

      Length of Torque Wrench 300 mm (11.8 in.)

      Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly.

      09224-00010

      without SST [Torque (N*m(kgf*cm, ft.*lbf))]

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]

      40 N*m

      408 kgf*cm

      30 ft.*lbf

      Note:

      If a component has been dropped or subjected to a strong impact, replace it.

      Tip:

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click hereClick here

    2. Connect the connector to the air fuel ratio sensor and wire harness clamp.

    3. Install the clamp to the air fuel ratio sensor.

  2. INSPECT FOR EXHAUST GAS LEAK