CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM, Diagnostic DTC:P099B and P099C

DTC Code DTC Name
P099B Shift Solenoid "G" Control Circuit Low (Shift Solenoid Valve SC)
P099C Shift Solenoid "G" Control Circuit High (Shift Solenoid Valve SC)

DESCRIPTION

Based on the signal received by the shift solenoid valve SC, the ECM uses the shift solenoid valve SLU to control the forward and reverse clutch pressure.

If there is an open or short in the shift solenoid valve SC circuit, the ECM stops sending current to the defective shift solenoid valve.

DTC Code

DTC Detection Condition

  1. Diagnosis Condition

  2. Malfunction Status

  3. Malfunction Time

  4. Other

Trouble Area

P099B

  1. The vehicle is being driven.

  2. There is a short in the shift solenoid valve SC circuit.

  3. 3 seconds

  4. 1-trip detection logic

  • Wire harness or connector

  • Continuously variable transaxle assembly (Shift solenoid valve SC)

  • ECM

P099C

  1. The vehicle is being driven.

  2. There is an open in the shift solenoid valve SC circuit.

  3. 0.5 seconds

  4. 1-trip detection logic

  • Wire harness or connector

  • Continuously variable transaxle assembly (Shift solenoid valve SC)

  • ECM

MONITOR DESCRIPTION

These DTCs indicate an open or short in the shift solenoid valve SC circuit. If there is an open or short in the shift solenoid valve SC circuit, the ECM detects the problem and stores the DTC.

WIRING DIAGRAM

C264610E59

CAUTION / NOTICE / HINT

Note:

  • Perform initialization when parts related to the continuously variable transaxle are replaced (Click here).

  • Check that no DTCs are stored after performing initialization (Click here).

PROCEDURE

  1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SC)

    1. C264597E31

      Disconnect the transmission wire connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      9 (SC) - Body ground

      20°C (68°F)

      11 to 15 Ω
      Table 1. Text in Illustration

      *a

      Component without harness connected

      (Transmission Wire)

    REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLYClick here

  2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)

    U123368E02

    1. Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      C111-41 (SC) - Body ground

      20°C (68°F)

      11 to 15 Ω
      Table 2. Text in Illustration

      *a

      Front view of wire harness connector

      (to ECM)

    REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSMISSION WIRE - ECM)

  3. REPLACE ECM

    1. Replace the ECM (Click here).

    PERFORM INITIALIZATION

    (Click here)

  4. REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

    1. Replace the continuously variable transaxle assembly (Click here).

    PERFORM INITIALIZATION

    (Click here)