BLOWER UNIT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Steering sensor

  • Steering angle neutral point (Initialize parking assist monitor system)

  • Steering angle setting

 Parking assist monitor system

Click here for Initialization

Click here for Calibration
Steering angle neutral point (Initialize panoramic view monitor system) Panoramic view monitor system

Click here for Initialization

Click here for Calibration

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B0084SX

Click here

Tech Tips

Before removing the blower assembly, set the air conditioning to recirculation mode.

PROCEDURE


  1. REMOVE AIR CONDITIONER UNIT ASSEMBLY

    Click here

  2. REMOVE NO. 2 INSTRUMENT PANEL WIRE (w/ PTC Heater)

    Click here

  3. REMOVE NO. 2 AIR DUCT

    Click here

  4. REMOVE BLOWER ASSEMBLY


    1. for LHD:


      1. B0084V7C01
        *A for 1-tier Type
        *B for 2-tier Type

        Disconnect the connector.

      2. Disengage each guide.

      3. B00876F

        Remove the 2 screws.

      4. Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.

    2. for RHD:


      1. B0088MCC01
        *A for 1-tier Type
        *B for 2-tier Type

        Disconnect the connector.

      2. Disengage each guide.

      3. B0084D1

        Remove the 2 screws.

      4. Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.