FRONT SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.

PROCEDURE


  1. INSTALL FRONT SPEED SENSOR


    1. Install the front speed sensor to the steering knuckle with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Keep the tip of the front speed sensor and installation hole free of foreign matter.

      • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

      • After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.

    2. A001T15C01
      *a Hook
      *b Clamp

      Engage the clamp to the front shock absorber assembly.

      Note

      Do not twist the front speed sensor wire harness when installing it.

    3. Engage the 2 hooks of front speed sensor clamp to the front shock absorber assembly.

      Note

      Do not twist the front speed sensor wire harness when installing it.

    4. A001YBZ

      Install the front flexible hose to the front shock absorber assembly with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    5. Install the 2 front speed sensor clamps with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the front speed sensor wire harness when installing it.

    6. Engage the clamp to the vehicle body.

      Note

      Do not twist the front speed sensor wire harness when installing it.

    7. Engage the clamp to the vehicle body.

      Note

      Do not twist the front speed sensor wire harness when installing it.

    8. Connect the connector.

    9. Return the front fender liner to its original position.

  2. INSTALL FRONT FENDER LINER


    1. Install the front fender liner with the 3 clips.

    2. Install the 4 screws.

  3. INSTALL ROCKER PANEL MOULDING

    Click here

  4. INSTALL FRONT WHEEL

    Click here

  5. CHECK FOR SPEED SENSOR SIGNAL

    Click here