PANORAMIC VIEW MONITOR SWITCH INSPECTION

PROCEDURE


  1. INSPECT NO.2 COMBINATION SWITCH ASSEMBLY (for Type A)


    1. Remove the No. 2 combination switch assembly.

    2. B005BCQC01
      *a

      Component without harness connected

      (Integration Control & Panel Assembly (Panoramic View Monitor Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      5 (D) - 17 (E) Panoramic view monitor switch on (not protruding) Below 1 Ω
      Panoramic view monitor switch off (protruding) 10 kΩ or higher

      If the result is not as specified, replace the No. 2 combination switch assembly (panoramic view monitor switch).

    3. B0059QRC01
      *a

      Component without harness connected

      (Integration Control & Panel Assembly (Panoramic View Monitor Switch))

      Check that the switch illuminates.


      1. Apply battery voltage to the No. 2 combination switch assembly (panoramic view monitor switch) and check that the switch illuminates.

        OK
        Connection Specified Condition

        Battery positive (+) → Terminal 8 (ILL+)

        Battery negative (-) → Terminal 15 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the No. 2 combination switch assembly (panoramic view monitor switch).

    4. Install the No. 2 combination switch assembly.

  2. INSPECT NO.2 COMBINATION SWITCH ASSEMBLY (for Type B)


    1. Remove the No. 2 combination switch assembly.

    2. B0057GFC07
      *a

      Component without harness connected

      (Integration Control & Panel Assembly (Panoramic View Monitor Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      5 (D) - 17 (E) Panoramic view monitor switch on (not protruding) Below 1 Ω
      Panoramic view monitor switch off (protruding) 10 kΩ or higher

      If the result is not as specified, replace the No. 2 combination switch assembly (panoramic view monitor switch).

    3. B0059FPC05
      *a

      Component without harness connected

      (Integration Control & Panel Assembly (Panoramic View Monitor Switch))

      Check that the switch illuminates.


      1. Apply battery voltage to the No. 2 combination switch assembly (panoramic view monitor switch) and check that the switch illuminates.

        OK
        Connection Specified Condition

        Battery positive (+) → Terminal 8 (ILL+)

        Battery negative (-) → Terminal 15 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the No. 2 combination switch assembly (panoramic view monitor switch).

    4. Install the No. 2 combination switch assembly.