STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY INSPECTION

PROCEDURE

  1. INSPECT STOP AND START SYSTEM CANCEL SWITCH (for 1AD-FTV)

    1. A273347C01

      *a

      Component without harness connected

      (Stop and Start System Cancel Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      2 (ECU) - 4 (E)

      Pushed

      Below 1 Ω

      Not pushed

      10 kΩ or higher

      If the result is not as specified, replace the stop and start system cancel switch.

    2. A273347C02

      *a

      Component without harness connected

      (Stop and Start System Cancel Switch)

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.

      OK

      Measurement Condition

      Specified Condition

      Battery positive (+) → 1 (ILL+)

      Battery negative (-) → 5 (ILL-)

      Illuminates

      If the result is not as specified, replace the stop and start system cancel switch.

  2. INSPECT STOP AND START SYSTEM CANCEL SWITCH (for 3ZR-FAE)

    1. A285506C11

      *a

      Component without harness connected

      (Stop and Start System Cancel Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      8 (ECU) - 5 (E)

      Pushed

      Below 1 Ω

      Not pushed

      10 kΩ or higher

      If the result is not as specified, replace the stop and start system cancel switch.

    2. A285506C12

      *a

      Component without harness connected

      (Stop and Start System Cancel Switch)

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.

      OK

      Measurement Condition

      Specified Condition

      Battery positive (+) → 7 (ILL+)

      Battery negative (-) → 6 (ILL-)

      Illuminates

      If the result is not as specified, replace the stop and start system cancel switch.