ROOF SUNSHADE SYSTEM DATA LIST / ACTIVE TEST
DATA LIST
Tip:Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note:In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Roof / Data List.
Read the Data List according to the display on the GTS.
Body Electrical > Sliding Roof > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Open Switch
Open switch signal
ON or OFF
ON: Open switch pressed
OFF: Open switch not pressed
-
Close Switch
Close switch signal
ON or OFF
ON: Close switch pressed
OFF: Close switch not pressed
-
Front SW Auto Operation
Roof sunshade auto function
ON or OFF
Customization status displayed
-
Hall IC1 Pulse
Hall IC1 pulse output
Lo or Hi
Lo and Hi repeat during motor operation
Lo: Hall IC1 output is low
Hi: Hall IC1 output is high
Hall IC1 Status
Status of Hall IC1
Normal or Error
Normal: Hall IC1 normal
Error: Hall IC1 not normal
-
Hall IC2 Pulse
Hall IC2 pulse output
Lo or Hi
Lo and Hi repeat during motor operation
Lo: Hall IC2 output is low
Hi: Hall IC2 output is high
Hall IC2 Status
Status of Hall IC2
Normal or Error
Normal: Hall IC2 normal
Error: Hall IC2 not normal
-
Ignition (Direct Signal)
Ignition switch signal
ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
-
Ignition (MPX)
Ignition switch signal (LIN signal)
ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
-
Open Switch Failure(Past)
Open switch failure signal (Past)
ON or OFF
ON: Roof sunshade open signal failure (Past)
OFF: No roof sunshade open signal failure (Past)
-
Close Switch Failure(Past)
Close switch failure signal (Past)
ON or OFF
ON: Roof sunshade close signal failure (Past)
OFF: No roof sunshade close signal failure (Past)
-
Open Switch Failure(Current)
Open switch failure signal (Current)
ON or OFF
ON: Roof sunshade open signal failure (Current)
OFF: No roof sunshade open signal failure (Current)
-
Close Switch Failure(Current)
Close switch failure signal (Current)
ON or OFF
ON: Roof sunshade close signal failure (Current)
OFF: No roof sunshade close signal failure (Current)
-
Number of Trouble Codes
Number of DTCs
Min.: 0, Max.: 255
Number of stored DTCs
-
ACTIVE TEST
Tip:Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Roof / Active Test.
According to the display on the GTS, perform the Active Test.
Body Electrical > Sliding Roof > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Slide Roof
Operate roof sunshade
OFF / Opn/Dwn / Clos/Up
-