FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click hereClick here

  4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side with Power Window)

    Click hereClick here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side with Power Window)

    Click hereClick here

  6. REMOVE FRONT DOOR TRIM COVER

    Click hereClick here

  7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Mirror Heater)

    Click hereClick here

  8. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Mirror Heater)

    Click hereClick here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY

    Click hereClick here

  11. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER

    Click here

  12. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click hereClick here

  13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    w/o Power Window:Click hereClick here

    w/ Power Window:Click hereClick here

  14. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP

    1. B372449C01
      V100155

      Protective Tape

      Apply protective tape around the front door glass outer weatherstrip.

    2. for Resin Type:

      1. B371101C02

        *a

        Protective Tape

        Disengage the claw (A).

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws (B) and remove the front door glass outer weatherstrip as shown in the illustration.

    3. for Plating Type:

      1. B371103C02

        *a

        Protective Tape

        Disengage the claw (A).

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws (B) and remove the front door glass outer weatherstrip as shown in the illustration.