POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

    Click here

  6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  7. REMOVE FRONT DOOR ASSIST GRIP COVER LH

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    1. B435751

      w/ Jam Protection Function:

      Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.

      Note:

      Be careful when removing the screws as the motor may fall and become damaged.

    2. B435752

      w/o Jam Protection Function:

      Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.

      Note:

      Be careful when removing the screws as the motor may fall and become damaged.