RELAY ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT STARTER RELAY (ST) (w/o Stop And Start System)

    1. A188757N06

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT STARTER NO. 1 RELAY (ST NO. 1) (w/ Stop And Start System)

    1. A188757N06

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the starter No. 1 relay.

  3. INSPECT STARTER NO. 2 RALAY (ST NO. 2) (w/ Stop And Start System)

    1. A188757N06

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the starter No. 2 relay.