PARK / NEUTRAL POSITION SWITCH INSPECTION

PROCEDURE

  1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    C208647C02

    *a

    Component without harness connected

    (Park/Neutral Position Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      • 2 (RB) - 6 (PL)

      • 4 (B) - 5 (L)

      Shift lever in P

      Below 1 Ω

      2 (RB) - 1 (RL)

      Shift lever in R

      Below 1 Ω

      • 2 (RB) - 9 (NL)

      • 4 (B) - 5 (L)

      Shift lever in N

      Below 1 Ω

      2 (RB) - 7 (DL)

      Shift lever in D, S, "+" or "-"

      Below 1 Ω

      • 2 (RB) - 6 (PL)

      • 4 (B) - 5 (L)

      Shift lever not in P

      10 kΩ or higher

      2 (RB) - 1 (RL)

      Shift lever not in R

      10 kΩ or higher

      • 2 (RB) - 9 (NL)

      • 4 (B) - 5 (L)

      Shift lever not in N

      10 kΩ or higher

      2 (RB) - 7 (DL)

      Shift lever not in D, S, "+" or "-"

      10 kΩ or higher

      If the result is not as specified, replace the switch.