NAVIGATION ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control)

Click here

Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System

Click here

Panoramic View Monitor System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B0084SX

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  3. REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET


    1. B008466

      Disconnect the connector.

    2. Disengage the 2 claws.

    3. B0088D2

      Remove the 2 screws and navigation antenna assembly with bracket.

  4. REMOVE NAVIGATION ANTENNA ASSEMBLY


    1. B0087P4C02
      B00847Z Remove in this Direction

      Disengage the 2 claws and 6 guides to remove the navigation antenna assembly as shown in the illustration.

  5. REMOVE NAVIGATION ANTENNA BRACKET