AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK

  1. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK

    1. Check that the initialization (determination of the initial position) of the headlight leveling motor (headlight unit) is performed when the ignition switch is turned to ON.

    2. Check that the headlight beam level control system warning light in the combination meter comes on for approximately 3 seconds when the ignition switch is turned to ON, and then turns off.

    3. Check that the headlight moves when all of the following conditions are met: 1) the rear of the vehicle is moved up or down, 2) the engine is running, 3) the vehicle is stopped, and 4) the light control switch is in the head position.

      Note:

      Make sure to change the vehicle height slowly.