FRONT DOOR SPEAKER INSPECTION

PROCEDURE


  1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for LH Side)


    1. With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.

    2. Check that there is no foreign matter inside the speaker.

    3. Check that the speaker cone is not damaged.

    4. B005SYLC18
      *a

      Component without harness connected

      (Front No. 1 Speaker Assembly)

      for 12 Speakers:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        H19-1 - H19-2 Always 4 Ω

        If the result is not as specified, replace the front No. 1 speaker assembly.

    5. B005S9BC16
      *a

      Component without harness connected

      (Front No. 1 Speaker Assembly)

      for 24 Speakers:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        H19-1 - H19-2 Always 4 Ω

        If the result is not as specified, replace the front No. 1 speaker assembly.

  2. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for RH Side)


    1. With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.

    2. Check that there is no foreign matter inside the speaker.

    3. Check that the speaker cone is not damaged.

    4. B005SYLC24
      *a

      Component without harness connected

      (Front No. 1 Speaker Assembly)

      for 12 Speakers:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        H1-1 - H1-2 Always 4 Ω

        If the result is not as specified, replace the front No. 1 speaker assembly.

    5. B005S9BC25
      *a

      Component without harness connected

      (Front No. 1 Speaker Assembly)

      for 24 Speakers:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        H1-1 - H1-2 Always 4 Ω

        If the result is not as specified, replace the front No. 1 speaker assembly.