FUEL INJECTOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel injector assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Replacement throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

  • Replacement of fuel injector assembly

 Inspection after repair Poor idle, engine start function, etc.

Click here

PROCEDURE


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

    Click here

  5. DISCONNECT NO. 1 FUEL HOSE


    1. B0026UC

      Disconnect the No. 1 fuel hose.

      Click here

  6. DISCONNECT NO. 2 FUEL HOSE


    1. B0024S9

      Disconnect the No. 2 fuel hose.

  7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

    Click here

  8. REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR ASSEMBLY


    1. B0025J7

      Disconnect the 4 wire harness clamps.

    2. Disconnect the 4 fuel injector connectors.

    3. Disconnect the purge VSV connector.

    4. B0028M4

      Remove the vacuum hose.

    5. Remove the 2 bolts and fuel delivery pipe together with the 4 fuel injector assemblies.

      Note

      Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe.

    6. B0026QVC01
      *a Protective Tape

      Remove the 2 No. 1 delivery pipe spacers.

    7. Remove the 4 injector vibration insulators.

    8. Using a screwdriver, remove the 4 spacers.

      Tech Tips

      Tape the screwdriver tip before use.

    9. Remove the O-ring from the spacer.

  9. REMOVE FUEL INJECTOR ASSEMBLY


    1. B0027ZUC01
      B0068HS Pull Out

      Remove the 4 fuel injector assemblies from the fuel delivery pipe.