LIGHTING SYSTEM OPERATION CHECK

  1. INSPECT ILLUMINATED ENTRY SYSTEM OPERATION

    Note:

    Perform this inspection with the customizable parameters set to the initial settings.

    Tip:

    When inspecting the following functions, make sure that the map light switch and No. 1 room light switch are DOOR position.

    1. The interior light control illuminates the lights below.

      • Map light assembly

      • No. 1 room light assembly

      • Power switch illumination

    2. The operation and operating condition of this control are described below.

      Operation

      Condition

      Lights fade in and illuminate constantly

      Any door is opened when all the doors are closed.

      Lights illuminate for 15 seconds, and then fade out

      • When any of the following conditions is met:

      • The key is brought within any vehicle exterior detection area when the power switch is off and all the doors are closed.

      • Any door is unlocked when the power switch is off and all the doors are closed and locked.

      • The power switch is turned from on (ACC) to off when all doors are closed.

      • All the doors are closed when any door is opened and the power switch is off.

      Lights fade out immediately

      • When either of the following conditions is met:

      • The power switch is turned from off to on (ACC) when all the doors are closed.

      • All the doors are locked when the power switch is off, all the doors are closed and any door is unlocked.

  2. BATTERY SAVING CONTROL SYSTEM OPERATION

    1. The battery saving control (basic function) illuminates the lights and parts below.

      • Power switch illumination

      1. The operation and operating condition of this control are described below.

        Operation

        Condition

        Battery saving (basic function)

        The doors remain in the same condition for 20 minutes and the key is outside the vehicle exterior detection area.

    2. The battery saving control (interior light auto cut function) illuminates the lights and parts below.

      • Map light assembly

      • No. 1 room light assembly

      • No. 2 room light assembly

      • Vanity light assembly

      1. The operation and operating condition of this control are described below.

        Operation

        Condition

        Battery saving (interior light auto cut function)

        20 minutes has elapsed since the power switch was turned off, regardless of whether the doors are open or closed and regardless of the map light and No. 1 room light switch position.