SEAT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR


    1. A001WC5

      Disengage the clamp and disconnect the connector.

    2. A001XTQC01
      B008LJK Remove in this Direction (1)
      B008KJ9 Remove in this Direction (2)

      Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.

  3. REMOVE SEAT POSITION AIRBAG SENSOR (for 6 Way Seat Type)


    1. A001XBF

      Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.

  4. REMOVE SEAT POSITION AIRBAG SENSOR (for 4 Way Seat Type)


    1. A001V1U

      Remove the nut and seat position airbag sensor.