FRONT BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Note:

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

Tip:

  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. REMOVE FRONT WHEEL

  2. DRAIN BRAKE FLUID

    Note:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE FRONT FLEXIBLE HOSE

    1. C272612

      Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.

    2. C272622

      Using a union nut wrench, disconnect the brake tube while holding the front flexible hose with a wrench.

      Note:

      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

    3. Remove the clip.

    4. C272623C01

      *1

      Front Speed Sensor Bracket

      *2

      Front Flexible Hose Bracket

      Remove the bolt (A) and separate the front speed sensor bracket and front flexible hose bracket from the absorber bracket.

    5. Remove the bolt (B) and front flexible hose from the steering knuckle.