POWER TRUNK LID SYSTEM, Diagnostic DTC:B2222, B2225

DTC Code DTC Name
B2222 PBD/PTL Pulse Sensor
B2225 PBD/PTL Motor Clutch Malfunction

DESCRIPTION

DTC B2222 is output when there is a malfunction in the door pulse sensor system inside the luggage closer motor assembly and a normal waveform is not input to the door pulse sensor during a power trunk lid operation. Also, this DTC is output when there is a malfunction in the power trunk lid drive power source.

DTC B2225 is output if there is a malfunction in the clutch circuit of the luggage closer motor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from
B2222 PBD/PTL Pulse Sensor Pulse sensor of luggage closer motor assembly has malfunction or activation power supply has malfunction

  • Harness or connector

  • Luggage closer motor assembly

 ○ Luggage closer motor assembly
B2225 PBD/PTL Motor Clutch Malfunction Clutch of luggage closer motor assembly has malfunction or activation power supply has malfunction

  • Harness or connector

  • Luggage closer motor assembly

 ○ Luggage closer motor assembly

WIRING DIAGRAM

B006BZRE04
*1 from Battery
*2 PTL
*3 Luggage Closer Motor Assembly

CAUTION / NOTICE / HINT

Note


  • If a luggage closer motor assembly DTC is output, the luggage compartment door closer and power trunk lid stops operating.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • If the replacement, removal and installation of the luggage closer motor assembly or disconnection of the connectors of the luggage closer motor assembly has been performed, initialize the power trunk lid system.

    Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Back Door > Clear DTCs

    2. Check for DTCs.

      Click here


      Body Electrical > Back Door > Trouble Codes
      OK
      DTC B2222 and B2225 are not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. CHECK LUGGAGE CLOSER MOTOR ASSEMBLY (INPUT VOLTAGE)


    1. Disconnect the L10 luggage closer motor assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L10-12 (B) - Body ground Always 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR