STEERING PAD SWITCH INSPECTION

PROCEDURE

  1. INSPECT STEERING PAD SWITCH ASSEMBLY

    1. Measure the resistance according to the value(s) in the table below.

      E317459C01

      *A

      w/ Shift Paddle Switch

      *B

      w/ Lane Departure Alert System

      *a

      Component without harness connected

      (Steering Pad Switch Assembly)

      *b

      Volume+

      *c

      Volume-

      *d

      MODE

      *e

      Seek+

      *f

      Seek-

      *g

      Off hook

      *h

      On hook

      *i

      Lane departure alert

      -

      -

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      z1-1 (HO) - A-1 (HO)

      Always

      Below 2.5 Ω

      z1-10 (AU1) - z1-8 (EAU)

      No switch pushed

      95 to 105 kΩ

      Seek+ switch pushed

      Below 2.5 Ω

      Seek- switch pushed

      313 to 345 Ω

      Volume+ switch pushed

      950 to 1050 Ω

      Volume- switch pushed

      2955 to 3265 Ω

      z1-9 (AU2) - z1-8 (EAU)

      No switch pushed

      95 to 105 kΩ

      MODE switch pushed

      Below 2.5 Ω

      On hook switch pushed

      313 to 345 Ω

      Off hook switch pushed

      950 to 1050 Ω

      z1-2 (SFTU) - z6-2 (SFTU)*1

      Always

      Below 2.5 Ω

      z1-3 (SFTD) - z6-3 (SFTD)*1

      Always

      Below 2.5 Ω

      z1-6 (ECC) - z6-7 (ECC)*1

      Always

      Below 2.5 Ω

      z1-4 (DIST) - z1-6 (ECC)*2

      No switch pushed

      1 MΩ or higher

      Lane departure alert switch pushed

      228 to 252 Ω

      • *1: w/ Shift Paddle Switch

      • *2: w/ Lane Departure Alert System

      Tip:

      If the result is not as specified, replace the steering pad switch assembly.