REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Double-folding Seat Type RH Side) REMOVAL
CAUTION / NOTICE / HINT
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
REMOVE REAR SEAT CUSHION HINGE COVER
Using a moulding remover, detach the 3 claws and remove the cover.
REMOVE REAR SEAT CUSHION HINGE COVER RH
Using a moulding remover, detach the 3 claws and remove the cover.
REMOVE REAR SEAT CUSHION ASSEMBLY RH
Pull the rear seat cushion band and release the lock.
Remove the 2 bolts and seat cushion.
Note:Be careful not to damage the vehicle body.
REMOVE REAR SEAT HEADREST ASSEMBLY
Remove the headrest.
REMOVE REAR SEATBACK COVER
Press the seatback lock release button to release the lock and fold down the seatback.
-
Using a screwdriver, detach the 4 claws and remove the cover.
Tip:Tape the screwdriver tip before use.
REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH
Using a clip remover, detach the 5 clips.
Detach the 2 claws and remove the carpet.
REMOVE REAR SEATBACK ASSEMBLY RH
Remove the bolt and detach the claw, and then disconnect the outer belt.
Remove the 2 bolts that secure the seatback to the floor.
Fold down the seatback, remove the bolt from the hinge, and then remove the seatback.
Note:Be careful not to damage the vehicle body.
REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
Remove the bolt and hinge.
REMOVE REAR SEATBACK LOCK CONTROL LEVER BASE RH
Using a moulding remover, detach the 6 claws.
Move the cover in the direction of the arrow to detach the 2 guides and remove the lever base.
-
Detach the cable clamp and disconnect the cable.
REMOVE REAR DOOR SCUFF PLATE RH
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY
REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
REMOVE REAR FLOOR CARPET ASSEMBLY
REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
REMOVE REAR NO. 2 SEATBACK LOCK STRIKER SUB-ASSEMBLY RH
Remove the 2 bolts.
Detach the claw and remove the striker.
Note:Do not wipe off the grease on the sliding portion of the striker.
REMOVE REAR SEAT CUSHION LOCK STRIKER
Remove the 2 bolts and striker.