DRIVING SUPPORT BUZZER(for LHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point

  • Lane departure alert system (w/ Steering Control)

  • Simple intelligent parking assist system*1

  • Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

  • Pre-collision system

Click here

Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here


PROCEDURE


  1. REMOVE FUSE BOX OPENING COVER

    Click here

  2. REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)


    1. A001T8A

      Disengage the clamp.

    2. Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).

      Note

      If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.