NAVIGATION SYSTEM, Diagnostic DTC:B15F7

DTC Code DTC Name
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction

DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.

Tech Tips

The certification ECU (smart key ECU assembly) controls the entry and start system related items that are customizable via the multi-display assembly*1 or accessory meter assembly*2 screen.


  • *1: for 8 Inch Display

    *2: for 12.3 Inch Display

DTC No. Detection Item DTC Detection Condition Trouble Area
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction Certification ECU (smart key ECU assembly) vehicle setting processing malfunction

  • CAN communication system

  • Entry and start system

  • Certification ECU (smart key ECU assembly)

  • Radio receiver assembly

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      OK
      CAN communication system DTCs are not output.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO CAN COMMUNICATION SYSTEM Click here

    OK

  2. CHECK ENTRY AND START SYSTEM


    1. Check if the entry and start system is malfunctioning.

      for Start Function: Click here

      for Entry Function: Click here xxx

      Tech Tips

      Customization may not be possible depending on the malfunction in the entry and start system.

      OK
      No malfunctions are present in the entry and start system.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO ENTRY AND START SYSTEM for Start Function: Click here
    GO TO ENTRY AND START SYSTEM for Entry Function: Click here xxx

    OK

  3. CHECK CUSTOMIZE ITEMS


    1. Display the vehicle customization screen.

    2. Make a note of the customizable items for each certification ECU related system.

      Tech Tips

      The items shown as customizable via the navigation system vehicle customization screen can also be changed using the GTS. In the following step, the GTS will be used.


      1. To match the items on the multi-display assembly*1 or accessory meter assembly*2 with the items on the GTS, check the customize parameters list for the entry and start system related items that can be customized via the multi-display assembly*1 or accessory meter assembly*2 screen.

        for Start Function: Click here

        for Entry Function: Click here xxx


        • *1: for 8 Inch Display

          *2: for 12.3 Inch Display

    3. Using the GTS, check that it is possible to change the settings of the customize parameters that are available for customization via the multi-display assembly*1 or accessory meter assembly*2 screen.

      OK
      The items available for customization via the multi-display assembly*1 or accessory meter assembly*2 screen can be customized successfully using the GTS.

      • *1: for 8 Inch Display

        *2: for 12.3 Inch Display

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)