VANE PUMP(for 2KD-FTV) INSTALLATION

PROCEDURE

INSTALL VANE PUMP ASSEMBLY
1. MP Grease
  
  Install in this Direction
  
  Coat a new O-ring with MP grease and install it to the vane pump assembly.
2. Install the vane pump assembly with the 2 nuts.
  
  Torque:
  
  39 N*m { 398 kgf*cm, 29 ft.*lbf }
CONNECT PRESSURE FEED TUBE ASSEMBLY
1. *a Torque Wrench Fulcrum Length
  
  Using a union nut wrench, connect the tube to the vane pump assembly.
  
  Torque:
  
  Specified tightening torque
  
  44 N*m { 449 kgf*cm, 32 ft.*lbf }
  
  Note
  
  Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.
  Tech Tips
  - Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
  - When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 40.5 N*m (413 kgf*cm, 30 ft.*lbf)
CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
1. Connect the oil reservoir to pump hose with slide the clip.
  Tech Tips
  - Connect the pump side of the oil reservoir to pump hose so that the paint mark faces the front of the vehicle.
  - Make sure the claw of the clamp on the vane pump assembly side faces the front of the vehicle.
ADD POWER STEERING FLUID
ADJUST POWER STEERING FLUID

Click here
CHECK FOR POWER STEERING FLUID LEAK
INSTALL FRONT FENDER APRON SEAL LH
1. Attach the new 6 clips to install the front fender apron upper seal.
INSTALL FRONT WHEEL LH

Click here

	MP Grease
	Install in this Direction