FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of LHD vehicles.

PROCEDURE

  1. INSTALL NO. 2 INSTRUMENT PANEL WIRE

    1. B339293C01

      *1

      Connector Lock

      Connect the airbag connector to the instrument panel passenger without door airbag assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    2. Push in the connector lock to install the airbag connector.

    3. Attach the connector clamp to install the No. 2 instrument panel wire to the instrument panel passenger without door airbag assembly.

  2. INSTALL INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

    1. Attach the 3 rear hooks of the instrument panel passenger without door airbag assembly to the rear of the airbag door.

    2. Push in the instrument panel passenger without door airbag assembly to attach the 3 front hooks to the front of the airbag door.

    3. Install the instrument panel passenger without door airbag assembly with the 2 screws.

  3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click hereClick here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here