SFI SYSTEM(w/o EGR System), Diagnostic DTC:P060E

DTC Code DTC Name
P060E Internal Control Module Throttle Position Performance

DESCRIPTION

The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. As the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals deviate, a DTC is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Memory

P060E

Internal Control Module Throttle Position Performance

Either condition is met (1 trip detection logic):

  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

ECM

Comes on

DTC stored

CONFIRMATION DRIVING PATTERN

  1. Turn the engine switch off.

  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  3. Connect the cable to the negative (-) battery terminal.

  4. Turn the engine switch on (IG) and wait for 16 seconds or more.

PROCEDURE

  1. CHECK FOR DTC

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the tester on.

    4. Clear DTCs.

      Click here

      Powertrain > Engine and ECT > Clear DTCs

    5. Turn the tester off.

    6. Turn the engine switch off.

    7. Disconnect the intelligent tester.

    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    9. Connect the cable to the negative (-) battery terminal.

    10. Connect the intelligent tester to the DLC3.

    11. Turn the engine switch on (IG) and turn the tester on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / DTC.

    14. Check for DTCs.

      Powertrain > Engine and ECT > Trouble Codes

      OK

      P060E is not output.

      Result

      Result

      OK

      NG
    OK

    CHECK FOR INTERMITTENT PROBLEMS

    Click here

    NG

    REPLACE ECM

    Click here