STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note:

w/ VSC:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE

  1. INSTALL LOWER STEERING WHEEL BOSS COVER (for Hatchback, Wagon)

    1. Engage the 4 pins and 2 claws to install a new lower steering wheel boss cover to the steering wheel sub-assembly.

  2. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

    1. Engage the 2 guides to install the 2 transmission shift switch assemblies with No. 1 switch wire to the steering wheel sub-assembly.

    2. Install the 2 transmission shift switch assemblies to the steering wheel sub-assembly with the 2 screws.

      1.3 N*m

      13 kgf*cm

      12 in.*lbf

  3. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)

    1. Install the cruise control switch wire.

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. INSTALL STEERING SHAKE DAMPER (for Hatchback, Wagon with CVT)

    1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

      2.35 N*m

      24 kgf*cm

      21 in.*lbf

  6. INSTALL STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

    1. Engage the 4 claws, 2 pins and 2 guides to install the steering wheel ornament to the steering wheel sub-assembly.

    2. Install the 2 screws.

      2.35 N*m

      24 kgf*cm

      21 in.*lbf

  7. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

    Click here

  8. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  9. INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY (w/o VSC)

    Click hereClick here

  10. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (w/ VSC)

    Click hereClick here

  11. INSTALL STEERING WHEEL ASSEMBLY

    1. C272233C01

      *a

      Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Install the steering wheel assembly set nut.

      50 N*m

      510 kgf*cm

      37 ft.*lbf

    3. Connect each connector to the spiral cable sub-assembly.

  12. CHECK STEERING WHEEL CENTER POINT

  13. INSTALL HORN BUTTON ASSEMBLY

    Click here