NAME PLATE ATTACHMENT POSITION

  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tip:

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note:

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tip:

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

B370421C01

*1

NO. 1 BACK DOOR NAME PLATE

*2

NO. 2 BACK DOOR NAME PLATE

●

Non-reusable part

-

-

  1. NO. 2 BACK DOOR NAME PLATE

    B370425C01

    *a

    Profile of Back Door Glass Sub-assembly

    -

    -

    Standard Measurement

    Area

    Measurement

    Area

    Measurement

    A

    136.9 to 138.9 mm (5.39 to 5.47 in.)

    B

    134.7 to 136.7 mm (5.30 to 5.38 in.)

    C

    15.6 to 17.6 mm (0.614 to 0.693 in.)

    -

    -

  2. INSTALL NO. 1 BACK DOOR NAME PLATE

    B370424C01

    *a

    Profile of Back Door Glass Sub-assembly

    *b

    Center Line of Back Door Glass Sub-assembly

    Standard Measurement

    Area

    Measurement

    Area

    Measurement

    A

    100.6 to 102.6 mm (3.96 to 4.04 in.)

    -

    -