FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. REMOVE FRONT FENDER LINER

    Tech Tips

    Use the same procedure for the LH side and RH side Click here.

  4. REMOVE FRONT SPEED SENSOR


    1. B005ZJ7

      Disconnect the front speed sensor connector and disengage the 2 clamps.

    2. B005XZLE01
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Remove the bolt and separate the No. 2 sensor clamp from the body.

    3. B005XHTE01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Flexible Hose

      Remove the bolt, No. 1 sensor clamp and front flexible hose together from the front shock absorber assembly.

    4. B005XTI

      Disengage the clamp from the front shock absorber assembly.

    5. Remove the bolt and front speed sensor from the steering knuckle.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.