STEERING ANGLE SENSOR (w/ VSC) REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE STEERING PAD


    1. A01DZ8KE01
      Text in Illustration
      *1 Screw Case

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A01DW9M

      Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  4. REMOVE STEERING WHEEL ASSEMBLY


    1. Remove the steering wheel assembly set nut.

    2. A01DZ8BE03

      Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  5. REMOVE LOWER STEERING COLUMN COVER

    A01E07KE01

    1. Remove the 3 screws and cover lower.

  6. REMOVE UPPER STEERING COLUMN COVER

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    A01DYGVE01

    1. Disconnect the connectors from the spiral cable.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

    2. Detach the 3 claws and remove the spiral cable.