NAVIGATION SYSTEM(for Navigation Receiver Type) Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM

A005A6KE56
*a Parking Brake Switch Assembly
*b Navigation Receiver Assembly

PROCEDURE


  1. CHECK BRAKE WARNING LIGHT


    1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

      OK
      The brake warning light operates as specified above.

    NG

    GO TO BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)


    1. Disconnect the L38 navigation receiver assembly connector.

    2. Disconnect the A25 parking brake switch assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L38-15 (PKB) - A25-1 Always Below 1 Ω
      L38-15 (PKB) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR