POWER WINDOW CONTROL SYSTEM Driver Side Power Window does not Operate with Power Window Master Switch
| DTC Code | DTC Name |
|---|---|
| Driver Side Power Window does not Operate with Power Window Master Switch |
DESCRIPTION
When the ignition switch is ON, the front door window regulator assembly (for driver door) is operated by the power window regulator master switch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
Remove the power window regulator master switch assembly.
Inspect the power window regulator master switch assembly.
Result
Proceed to
OK
NG
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - FRONT DOOR WINDOW REGULATOR ASSEMBLY (FOR DRIVER DOOR))
for LHD
Disconnect the H5 power window regulator master switch assembly connector.
Disconnect the H9 front door window regulator assembly (for driver door) connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
H5-3 (U) - H9-1 (U)
Always
Below 1 Ω
H5-3 (U) or H9-1 (U) - Body ground
Always
10 kΩ or higher
H5-4 (D) - H9-2 (D)
Always
Below 1 Ω
H5-4 (D) or H9-2 (D) - Body ground
Always
10 kΩ or higher
for RHD
Disconnect the G5 power window regulator master switch assembly connector.
Disconnect the G9 front door window regulator assembly (for driver door) connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
G5-6 (U) - G9-1 (U)
Always
Below 1 Ω
G5-6 (U) or G9-1 (U) - Body ground
Always
10 kΩ or higher
G5-5 (D) - G9-2 (D)
Always
Below 1 Ω
G5-5 (D) or G9-2 (D) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR