CAUTION / NOTICE / HINT
Note
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.
PROCEDURE
REMOVE HV BATTERY
REMOVE FRONT DOOR SCUFF PLATE RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE REAR DOOR SCUFF PLATE RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side)
Tech Tips
Use the same procedure as for the LH side Click here.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE CENTER PILLAR LOWER GARNISH RH
Tech Tips
Use the same procedure as for the LH side Click here.
REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
REMOVE REAR NO. 1 HEATER REGISTER BEZEL
Remove the 2 clips and rear No. 1 heater register bezel.
REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT
Turn back the front floor carpet to a position where the No. 2 hybrid battery intake duct can be removed.
Remove the 2 clips.
Disengage the 2 guides and remove the No. 2 hybrid battery intake duct.
REMOVE INTEGRATION CONTROL AND PANEL
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE UPPER INSTRUMENT PANEL FINISH PANEL
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE INSTRUMENT PANEL BOX ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Tech Tips
Use the same procedure as for LHD Click here.
REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
LOOSEN ADJUSTING NUT
*1 | Lock Nut |
*2 | Adjusting Nut |
Remove the lock nut and loosen the adjusting nut.
SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
*a | Turn |
*b | Hold |
Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 4 bolts and separate the No. 1 parking brake cable assembly.
Disengage the 2 wire harness clamps.
Remove the No. 1 parking brake cable assembly from the clamp.
Disconnect the parking brake switch connector.
Disengage the wire harness clamp.
Remove the 2 bolts, nut and parking brake control pedal assembly.