CHECK FUEL LEAK
CAUTION:
During ACTIVE TEST mode, engine speed goes high and combustion noise becomes loud, so pay attention.
During ACTIVE TEST mode, fuel becomes high pressure, so take much care not to expose your eyes, hands, or body to the fuel.
Check that there are no leaks from any part of the fuel system when the engine stops.
If there is fuel leakage, replace those parts.
While cranking or starting the engine, check that there are no leaks from any part of the fuel system.
If there is fuel leakage, replace those parts.
Disconnect the return hose from the common rail.
While cranking the engine, check fuel leakage from the return pipe.
If there is fuel leakage, replace the common rail assembly Click here.
*1 | Intelligent Tester |
Connect the intelligent tester to the DLC3.
Start the engine and push the intelligent tester main switch ON.
Select the FUEL LEAK test of ACTIVE TEST mode on the intelligent tester.
If you have no intelligent tester, depress the accelerator pedal quickly and fully to increase the engine speed at maximum and keep it for 2 seconds. Repeat this operation several times.
Check that there are no leaks from any part of the fuel system.
Note
If the leakage from the return pipe is less than 10 cc (0.6 cu in.) in a minute, it is acceptable.
If there is fuel leakage, replace those parts.
Reconnect the return hose to the common rail.