CUSTOMIZE LEXUS PARKING ASSIST-SENSOR SYSTEM
Customizing with the GTS
Note
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the clearance sonar main switch on.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Sonar / Utility / Customize Setting.
Select the setting by referring to the table below.
Display | Default | Content | Setting | Relevant ECU |
---|---|---|---|---|
Fr Sensor Onset Range | Wide | Sets the detection operation range for the front center sensors. | Narrow or Wide
|
Clearance warning ECU assembly |
Rr Sensor Onset Range | Wide | Sets the detection operation range for the rear center sensors. | Narrow or Wide
|
Clearance warning ECU assembly |
Keep Sense Buzzer | Avail | Sounds the buzzer when the distance between the vehicle and obstacle does not change for more than 3 seconds. | Not Avail or Avail
|
Clearance warning ECU assembly |
Fr & Rr Buzzer Volume | M2 | Changes the buzzer volume setting. | L, M1, M2, M3 or H
|
Clearance warning ECU assembly |
Display | Default | Content | Setting | Relevant ECU |
---|---|---|---|---|
Sensor Condition N | Avail | Makes the front sensors available when the shift lever is in N. | Not Avail or Avail
|
Clearance warning ECU assembly |
Reverse Range Front Sensor | Fcrn | Changes the operation setting for the front sensors when the shift lever is in R. | F, Fcrn or F Stop
|
Clearance warning ECU assembly |
Non P/R Range Rear Sensor | R Stop | Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R. | R, Rcrn or R Stop
|
Clearance warning ECU assembly |
Display | Default | Content | Setting | Relevant ECU |
---|---|---|---|---|
Display Mode*1 | All | The display mode setting (when the LEXUS parking assist-sensor system is normal). | All or Undisp | Clearance warning ECU assembly |
*1: This item is used to allow or prevent the LEXUS parking assist-sensor system from being displayed on the multi-display assembly. For this model, some vehicles are not equipped with the multi-display assembly. For those vehicles, the Display Mode item is not available.
Customizing with multi-display assembly (w/ Navigation System)
Note
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Turn the engine switch on (IG).
Turn the clearance sonar main switch on.
Enter the following menus: Setup / Vehicle / LEXUS park assist.
Select the setting by referring to the table below.
Display | Default | Content | Setting | Relevant ECU |
---|---|---|---|---|
Alert volume | 3 | Sets the buzzer alert volume. | 1, 2, 3, 4 or 5
|
Clearance warning ECU assembly |
Display | On | The display mode setting (when the LEXUS parking assist-sensor system is normal). | On or Off | Clearance warning ECU assembly |
Distance Front | Wide | Sets the detection operation range for the front center sensors. | Narrow or Wide
|
Clearance warning ECU assembly |
Distance Rear | Wide | Sets the detection operation range for the rear center sensors. | Narrow or Wide
|
Clearance warning ECU assembly |