REMOVE ENGINE ROOM SIDE COVER
Remove the clip and engine room side cover.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE COWL TOP VENTILATOR LOUVER
Remove the cowl top ventilator louver Click here.
REMOVE NO. 1 ENGINE COVER
Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.
Note
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Detach the clamp and disconnect the mass air flow meter connector.
Disconnect the No. 2 ventilation hose.
Disconnect the air cleaner hose.
Detach the 4 clamps and remove the air cleaner cap.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Remove the 3 bolts and air cleaner case.
DISCONNECT WIRE HARNESS
Disconnect the 4 connectors and detach the 3 wire harness clamps.
Remove the bolt from the fuel hose protector.
REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket.
REMOVE FUEL HOSE PROTECTOR
Remove the bolt and fuel hose protector.
REMOVE FUEL TUBE SUB-ASSEMBLY
Disconnect the exhaust fuel addition injector connector.
Turn the retainer as shown in the illustration.
Disconnect the fuel tube from the exhaust fuel addition injector.
*1 | Check Valve |
Remove the check valve and gasket.
Remove the union bolt, gasket and fuel tube.
REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
*1 | Washer |
*2 | Nozzle Holder Clamp |
Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector and gasket.
REMOVE FUEL INJECTOR SEAL
*1 | Fuel Injector Seal |
Remove the fuel injector seal from the exhaust fuel addition injector.