REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Detach the 8 claws.
Disconnect the connector and remove the panel pad.
REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
Remove the clip.
Detach the clip and remove the cover.
REMOVE INSTRUMENT SIDE PANEL LH
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 6 claws and remove the side panel.
REMOVE NO. 1 SWITCH HOLE BASE
Detach the 5 claws.
Disconnect the connectors and remove the switch hole base.
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Remove the 2 screws.
Detach the 3 claws.
Remove the under cover and disconnect the connectors.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Using a screwdriver, detach the 2 claws and open the hole cover.
Tech Tips
Tape the screwdriver tip before use.
Remove the 2 bolts.
Detach the 16 claws.
Detach the 2 claws and remove the sensor.
Detach the 2 claws and disconnect the 2 control cables.
Remove the finish panel and then disconnect the connectors.
REMOVE CENTER DIFFERENTIAL LOCK SWITCH
Detach the 2 claws and remove the switch.